The toilet cover is an important part of the toilet, and its frequency of use is relatively high. It will inevitably cause some failures after a long time. What if the toilet lid breaks or breaks? What should be paid attention to when replacing the toilet lid? The following editor will bring you how to change the toilet lid .
How to change the toilet lid
First, close the toilet water supply pipe, which is conducive to draining the water in the water tank and the toilet; use a sponge to completely suck the water in the toilet hole. If the water tank is connected to the wall, first remove the bolts of the hanger, then remove the pair of bolts connected to the bottom of the water tank, remove the water tank, and then remove the cover to remove the adhesive in the water tank.
Remove the compression bolts and nuts. If it is too stubborn, it is easier to drop a few drops of lubricant. Then tighten the bolts or nuts to fix the water tank to the floor. Check whether the drain pipe with the drum removed is clean. The next step is to replace the toilet lid.
After removing the broken toilet lid, take the measuring tool and record the toilet hole distance, length, and width, so that it is more convenient to purchase the toilet lid. Measure the size of the toilet lid in advance, so as not to use the toilet lid you bought;
It is recommended that friends take a photo when buying a new toilet lid, and then show the photo to the merchant to let the merchant see whether the toilet is O-shaped, U-shaped, or V-shaped. These three types are more similar. Generally come Said to buy more V-shaped toilet lids.
Observe whether the new toilet cover accessories are complete, and then fix the bolts and buckles on the bracket. First, slide the two buckles on the left and right to see if it is convenient to insert them into the bolt holes. Put the bolt into the screw hole, and then fix the screwdriver, the purpose is to ensure that the bracket does not slide.
How to change the toilet cover ? Finally, align the new toilet cover with the bracket mouth. Generally speaking, the toilet cover will smoothly snap into the bracket, mainly for fixing. After the completion, the toilet cover will be replaced. The steps are very simple.
Conclusion of the article: Because the toilet lid is used frequently, it is prone to malfunction. Only by properly installing the toilet lid can the toilet lid be better used. If the replacement of the toilet lid is more troublesome, you can call the toilet after-sales service, and the general brand toilets will provide after-sales service. How to change the toilet cover is introduced here for everyone. I hope it will be helpful to everyone . If you need more knowledge, please continue to pay attention to the information platform of this website, and we will show you more exciting content in the future.
What, the decoration still uses his own money? ! The Qi family is decorated in installments, with an ultra-low annual interest rate of 3.55% and a maximum loan of 1 million. Apply now to enjoy the discount
If you are interested in brand cooperation, content cooperation, and advertising of this website, please send an email to :.
How to change the toilet lid
The XUNDA Pipe Joint & Repair Tape is a cold applied tape used for the corrosion protection and mechanical protection of field joint, fittings and specialty piping. It is suitable to protect pipe welds. The high adhesion butyl rubber adhesive is suitable during extreme cold weather application.
The Pipe Repair Tape shall be applied by hand or with a pipe wrapping machine.
The composition of the Pipe Joint & Repair Tape consists of two layers, butyl rubber adhesive layer and film backing.
Adhesive : Butyl rubber
Film Backing: Special blend of stabilized polyethylene
Pipe Repair Tape,Pvc Pipe Leak Repair Tape,Pipe Joint Tape ,Pipeline Joint Tape
Jining xunda pipe coating materials co., ltd. , https://www.pipeanticorrosion.com