Nowadays, LCD TVs have entered thousands of households, and wall-mounted LCD TVs are also very popular among everyone. Today, Jiajiaju.com teaches you the installation points of LCD brackets .
Different installation methods depending on the type of wall:
1, ordinary brick wall
No special tools and processes are required for installation. Just use a hammer drill to punch holes in the wall, screw up and hang the TV.
2, the wall
The wall is divided into solid wood and plasterboard walls. As long as the solid wood board is 50px thick, use a self-tapping screw to directly fill the ring. If it is a plasterboard wall, you need to select a positioning point, first use a utility knife to drill a hole in the center of the hanging point (the size that your finger can enter), and then put a 50px thick hole in the upper hole on the hanger. Long wooden slats allow the self-tapping screws to pass through the gypsum board during self-tapping and into the slats, increasing the area of ​​the force.
3, marble walls
Marble walls are divided into integral marble and patterned marble. For the whole marble slab, a glass drill is required. When using a glass drill, it is necessary to drill while drilling the glass drill bit to prevent the glass drill bit from burning out. If the glass drill is difficult to drill through the wall, the impact drill can be used when drilling halfway, but the impact drill must be placed in the electric drill, otherwise the marble will be cracked. Once the hole is in place, the expansion screw can be installed until it is tightened. For patterned marble, be careful when drilling, because the patterned marble itself has a grain on it, and the vibration force is slightly larger, which will cause the crack to expand.
4, glass wall
Behind the glass wall are brick walls and slab walls. If there is a brick wall behind the glass wall, after the selected position, first drill with glass, and also need to drill while drilling the glass drill. The selected glass drill must be larger than the impact drill bit of the brick wall, and the glass hole is well. After that, drill the brick wall inside with a hammer drill. In order to prevent the glass from being crushed when the screw is screwed, it is preferable to use a large screw of the expansion tube as a filling ring. The thickness of the fill ring can be selected to be slightly thicker than the glass, and then tighten the screw. If the back of the glass plate is a slab wall, you only need to use a glass drill to drill the glass hole. The glass hole should be slightly larger. After drilling the hole, you can put it into the filling ring and then use the self-tapping screws to self-tapping. The self-tapping screws must be selected. It is a little longer than the thickness of the glass + the thickness of the board .
The above is the knowledge of the installation of the LCD bracket for you. I want to know more about the information and can pay attention to the official website of our website.
Dongguan Maimeng Cultural Communication Co., LTD , http://www.aiberrycn.com