1. The above-mentioned violent edge a. The main saw blade is too blunt, the sawtooth is too small b. The main saw blade is too small above the plate c. The plate quality is too bad, soon the blunting saw d. Replace the saw blade e. Increase the main Saw blade f. Use less impurities and high quality plate
2, the following storm side (saw after the plate)
a. The secondary blade is too blunt b. The secondary blade width is not enough, too narrow c. The centerline of the primary and secondary blade is not coincident d. Replace the blade e. Change the blade or increase the blade thickness f. Readjust the secondary saw position
3, there is a trace of burnt (on sawed plate)
a.Saw blade is too blunt, too much saw blade on saw blade b.Speed ​​is too high or feed is too slow c.Change the saw blade and select the appropriate saw blade d.Select the appropriate speed and feed rate
4. The phenomenon that the workpiece is lifted by the auxiliary saw during sawing a. The secondary blade is too blunt b. The secondary blade is too high c. Replace the blade d. Lower the height of the secondary blade properly
2, the following storm side (saw after the plate)
a. The secondary blade is too blunt b. The secondary blade width is not enough, too narrow c. The centerline of the primary and secondary blade is not coincident d. Replace the blade e. Change the blade or increase the blade thickness f. Readjust the secondary saw position
3, there is a trace of burnt (on sawed plate)
a.Saw blade is too blunt, too much saw blade on saw blade b.Speed ​​is too high or feed is too slow c.Change the saw blade and select the appropriate saw blade d.Select the appropriate speed and feed rate
4. The phenomenon that the workpiece is lifted by the auxiliary saw during sawing a. The secondary blade is too blunt b. The secondary blade is too high c. Replace the blade d. Lower the height of the secondary blade properly
Din3093 En13411-3 Wire Rope Aluminium Ferrules,Din3093 Crimping Aluminum Sleeves,Din3093 Crimp Aluminum Ferrule
Lisheng Trading Co., Ltd. , http://www.jnbuckles.com