First, carefully wipe the outer surface of the lamp with a glasses cloth, do not leave stains, so as not to leave stains on the glass after the light is turned on (preferably wear gloves).
2. Find a small protrusion in the middle of the lamp, and face the small protrusion in the direction of the reflector.
3. Put one of the corners of the lamp bulb on the lamp foot, pay attention to the groove on the lamp, and correctly click on the protrusion on the lamp foot, then squeeze it to the outside with a little force, and the other side of the lamp is equally card. Above the lamp foot. Then lighten the lamp and check if both sides are correctly embedded in the protrusion of the lamp foot. Otherwise it will affect the start.
4. Install the glass shield in place and turn on the light. Note: The glass shield is installed as much as possible. On the one hand, it can isolate a part of the radiant heat, on the other hand, it will protect the water from splashing into the lamp and causing an explosion.
Modern Prefab Villas,Prefab Concrete Houses,Modern Prefab House,Low Cost Prefab Houses
Prefab House Co., Ltd. , http://www.china-steelframe.com