Syringe pump troubleshooting

With the support of science and technology and economy, the development of syringe pump is more in line with the practical application. The syringe pump has the advantages of uniform movement at full speed, high control accuracy, precise flow rate, good flexibility and no need of cleaning. Although the advantages of a lot of injection pump, but in practical applications, there will be unexpected situations occur, when a failure, the workers should be how to deal with it? Next, we will analyze the solution of the syringe pump fault. Syringe Pump Troubleshooting Solution 1: Alarm Indicator Blinking Solution: 1. Press [STOP] to cancel the buzzer sound. 2, close the intravenous injection pipeline. 3, to solve the cause of congestion. 4, open the intravenous injection line, press the [START] key to restart the injection. Two: flashing alarm indicator Solution: 1, press the [STOP] key to eliminate the buzzer sound. 2, replace the syringe, continue infusion. 3, take corrective measures, the alarm light continued flashing, please contact your local sales. Three: light flashes, battery alarm solution: 1, press [STOP] key to eliminate buzzer sound. 2, the pump into the AC or DC power supply as soon as possible. Each of these devices may experience problems more or less during use. These problems may sometimes be insignificant, but sometimes they can cause great harm to users, especially in some sensitive areas. If the device is in use Failure to use may not only affect the performance of the equipment, but also affect the safety of life. Therefore, these sensitive equipment failures need to be taken more seriously.

1. Product introduction

   Coal-based Column Denitrification Column Activated Carbon is cylindrical black particles. It has many characters, such as high porosity, high sulfur capacity, high desulfurization efficiency, large surface area, light weight, strong adsorption capacity, wear resistance, good water resistance, low air resistance, easy regeneration, not easy to break under high pressure etc. It is a commonly used in adsorbent.

2. Adsorption purification principle and process

   Coal-based denitrification Activated Carbon is divided into large pores (pore size greater than 50nrrt), the middle hole (pore size between 2 ~ 50nm) and micro-pore (pore size less than 2nm) three categories.

The denitrification activated carbon is by active carbon`s adsorption and catalytic activity of activated carbon. The strong catalytic effect of the active carbon for sulfur dioxide in gas, and a small amount of Oxygen in the oxidation reaction, the reaction of elemental S adsorbed the surface of activated carbon. When activated carbon desulfurization agent the adsorption reaches saturation, the desulfurization efficiency decreased obviously, it must carry on the regeneration. The regeneration of active carbon adsorption depends on the material, sulphur began to melt under atmospheric pressure is 190 degrees, 440 degrees Celsius will sublimate into gas, therefore, the general use of superheated steam temperature of about 450-500 degrees Celsius for the regeneration of activated carbon desulfurization agent. When the desulfurization agent reach high temperature, the elemental sulfur separate out activated carbon, the precipitation of sulfur into sulfur recovery pool, water cooled to form solid sulfur.

Column Denitrification Column Activated Carbon

Activated Carbon,Column Denitrification Column Activated Carbon,Air Purification Activated Carbon

Ningxia XingKai Silicon Industry Co., Ltd. , https://www.xingkaisic.com