Oven introduction and summary of its use


The oven is a device that uses an electric heating wire to heat the object. It is suitable for baking, drying, heat treatment, etc. in the range of 5~300 °C (some 200 °C higher) than room temperature, and the sensitivity is usually ±1 °C. Its model is many, but the basic structure is similar, generally consists of three parts: the box, the electric heating system and the automatic temperature control system.

Its use and precautions are summarized as follows:

1. The oven should be placed indoors in a dry and level place to prevent vibration and corrosion.

2. Pay attention to safe use of electricity, install a power supply knife of sufficient capacity according to the power consumption of the oven. Use enough power leads and have a good grounding wire.

3. The oven with the electric contact mercury thermometer type thermostat should connect the two wires of the electric contact thermometer to the two terminals on the top of the box. In addition, an ordinary mercury thermometer is inserted into the exhaust valve. (The thermometer in the exhaust valve is used to check the electrical contact mercury thermometer and observe the actual temperature inside the box.) Open the exhaust valve hole. Adjust the electric contact mercury thermometer to the required temperature and tighten the screws on the steel cap to achieve the purpose of constant temperature. However, care must be taken not to turn the indicator iron out of the scale when adjusting.

4. When all preparations are ready, put the sample into the oven, then connect and turn on the power. The red indicator light indicates that the box is heated. When the temperature reaches the controlled temperature, the red light turns off and the green light is on, and the temperature is started. In order to prevent temperature control failure, you must also look after it.

5. When placing the sample, please note that the arrangement should not be too dense. The test piece should not be placed on the heat sink to avoid affecting the upward flow of hot air. It is forbidden to bake flammable, explosive, volatile and corrosive items.

6. When you need to observe the sample in the working room, you can open the outer door and observe through the glass door. However, it is better to open the door as little as possible to avoid affecting the constant temperature. Especially when working above 200 °C, opening the door may cause the glass door to quench and rupture. Http://

7. There is a blasted oven, the blower must be turned on during heating and constant temperature, otherwise it will affect the uniformity of the temperature of the working chamber and damage the heating element.

8. After the work is completed, the power should be cut off in time to ensure safety.

9. Keep the inside and outside of the oven clean.

10. When using, the temperature should not exceed the maximum operating temperature of the oven.

11. In order to prevent burns, special tools should be used when handling samples.

Magnetic Assemblies are a high strength and low cost option for a huge variety of applications. The assemblies are usually produced with a magnet set into other non-magnetic material. The most common types are round base magnets or cup magnets, and channel magnets. They are made this way to channel and increase the magnetic force in a particular direction.

Magnetic Assemblies

Magnetic Assemblies,Square Magnetic Separator Grid,Round Separator Magnetic Grate,Ceramic Latch Channel Assembly Magnet

Jinyu Magnet (Ningbo) Co., Ltd. , http://www.magnetbonwin.com